Worked for about an hour on Sunday and about 4 hours on Monday to get moving along with assembling the wing frame.
First off was to assemble an aileron cable rub block. This is where the aileron cables will go and will avoid fraying or rubbing anything that would cause damage. The block had to be countersunk to make room for the rivet heads. I tried using the drill and that worked a little too good and settled for going slow by hand.
After that, it was time to start installing the compression tubes and drag brace tubes. This was pretty straight forward and it was all a bunch of bolting together.
After those were installed it was time to install and assemble the aileron bell crank brace. This had two pieces that were riveted to the trailing edge spar. This took a while because there were a good bit of holes to drill and rivets to pull. Overall is wasn’t that bad.
The last thing I accomplished today (Monday) was installing the wing tip bow. There wasn’t much to this part and it went pretty quick. I also drilled out a hole so the wing can be attached to a rotator when it comes time for painting and covering.
Finally starting to look like a wing. I have a few more things to accomplish and then it will be on to installing the ribs.
(5 hrs)